Gear Aid Aquasure+FD Urethane Repair Adhesive & Sealant Glue

How to use

1.) Instructions for use with SABREX® Use Black Witch as a cut-end sealant for SABREX®. Note:- SABREX® is also known as FLCC in some markets. Black Witch should be applied to the exposed face of the bottom sheath beneath the explosive and liner. Apply with a brush or stick. It should be worked into the black foam material until the foam cells are filled and covered with a smooth shiny coating that is uniform and continuous from edge to edge. - Black Witch should be allowed to cure for approximately one to two (1-2) hours before SABREX immersion. - Once opened, the 28g tube of Black Witch should be consumed within 30 days. Note: In trials a 28g tube has proved sufficient to coat more than ten (10) SABREX® exposed cut-ends. For further information please refer to below Black Witch Technical Data Sheet Revision 3. Issued 25.02.2014 and Black Witch SDS Revision 4. Issued 22.02.2012 - If the user has any further questions relating to safety or hazards concerning SABREX, please refer to the contact details on the SABREX User Instruction (CEU-205-01195) or Product Safety Datasheet (CEU-205-01196) 2.) Instructions for Neoprene repairs etc. Step 1: Apply Black Witch with a short, stiff brush. - Apply a thin even coat of adhesive to both surfaces. Step 2: When surfaces become ‘touch dry’ (i.e. adhesive is glossy and no longer transfers to the knuckles) align the bond edges and bond under maximum pressure. If possible continue to maintain the jointed surfaces under pressure until Black Witch is cured in approximately one to two hours. Fully test all repairs prior to product use. Note: The full technical cure period is approximately three days. In case of contact with hands wash using brush soap and water.